Zestaw naprawczy do opon bezdętkowych AMIO-01251

TIRE REPAIR KIT QUICK TIRE WHEEL REPAIR

It's a great replacement for your spare tire. It's also an ideal addition to your car. It's compatible with tubeless tires. This repair kit will allow you to repair punctures quickly and effectively.

Its small size makes it very handy, so you can always have it at hand. You never know what might happen on the road, so it's worth checking out our set!

INCLUDED

• drill with handle
• awl with a handle
• 5 vulcanizing cords, each 10 cm long
• glue 12g

The kit allows for quick repair of a punctured tire.

Perfect for off-road use when replacing a flat tire is not possible.

However, please remember that this is a temporary solution that allows you to reach your destination or the nearest tire repair shop. The kit is not suitable for a cut tire or sidewall puncture, but only for areas with tread.

Instructions for use:

1. Remove the nail from the area where the tire was punctured.

2. Coat the cutter with the included glue and drive it into the hole left by the nail, following the angle at which the nail entered the tire, to fill the hole well with glue.

3. Thread the cord onto the awl and bend it in half, ends up.

4. Coat the cord with glue and press the threaded cord into the nail hole using an awl, following the angle of the previous penetration. Firmly push the awl and cord through the damaged area.

Remember to pass the cord through the entire tire layer.

Be careful not to pull the entire cord inward.

The two ends of the string should extend approximately 0.5-1cm above the tire tread. Firmly remove the awl from the tire (do not twist the awl inside the tire while removing it – this may cause it to break).

5. Cut off the two protruding ends of the cord, leaving 5 mm above the tire. As you drive, the cord will be flush with the tread surface.