Tubeless tire repair kit amio-01251

TIRE REPAIR KIT QUICK TIRE REPAIR WHEEL Perfect as axa0spare wheel replacement.xa0Ideal as car equipment.xa0Suitable for tubeless tires. The repair kit will allow you to repair punctures quickly and effectively. Its small size makes it very handy, so you can always have it at hand. You never know what will happen on the road, so it is worth taking a look at our set! IN THE SET: drill with handle, awl with handle, 5 vulcanizing cords, each 10 cm long, 12 g glue. The set allows you to quickly repair a punctured tire. It works perfectly in the field, when it is not possible to replace a punctured tire. However, it should be remembered that this is a temporary solution that allows you to reach your destination or the nearest tire repair shop. The set is not suitable for a cut tire or side puncture, but only in places where there is tread. Instructions for use: 1. Remove the nail from the place where the tire was punctured.2.xa0Apply the enclosed glue to the cutter and drive it into the holexa0left by the nail according to the angle at which the nail entered the tire, to fill the hole well with glue.3.xa0Thread the string onto the awl and bend it in half, with the ends facing up.4. Apply glue to the string and press the threaded string into the nail hole using the awlxa0, according to the angle of earlier penetration. With a firm movement, push the awl with the string through the damaged spot. Remember that the string should go through the entire tire layer. Be careful not to pull the entire string inside. The two ends of the string should protrude approx. 0.5 - 1 cm above the tire tread.xa0With a firm movement, remove the awl from the tirexa0 (you should not turn the awl inside the tire while pulling it out - this may cause it to break).5. Cut off the two protruding ends of the string0, leaving 5 mm above the tire. The string will be flush with the tread surface when driving.