RigExpert AA-600

( Užsakoma prekė, pristatymas per 9 dienas )

RigExpert AA-600

RigExpert AA-600, AA-1000 and AA-1400 are powerful antenna analyzer designed for testing, checking, tuning or repairing antennas and antenna feedlines.

Graphical SWR (Standing Wave Ratio) and impedance, as well as Smith/polar chart displays are key features of this analyzer which significantly reduce the time required to adjust an antenna.

Easy-to use measurement modes, as well as additional features such as connection to a personal computer make RigExpert AA-600, AA-1000 and AA-1400 attractive for professionals and hobbyists.

AA-600, AA-1000 and AA-1400 are available in non-US version (with ability to display Smith chart) and US version (displaying a polar chart instead).

The following tasks are easily accomplished by using these analyzers:

• Rapid check-out of an antenna
• Tuning an antenna to resonance
• Antenna SWR and impedance measurement and comparison before and after specific event (rain, hurricane, etc.)
• Making coaxial lines or measuring their parameters
• Cable testing and fault location
• Measuring capacitance or inductance of reactive loads

Frequency range:0.1 to 600 MHz

Frequency entry:1 kHz resolution

Measurement for25, 50, 75 and 100-Ohm systems

SWR measurement range:1 to 100 in numerical mode,
1 to 10 in graph mode

SWR display:numerical or easily-readable bar

R and X range:0…10000, -10000…10000 in numerical mode,
0…1000, -1000…1000 in graph mode

Display modes:
– SWR at single or multiple frequencies
– SWR, return loss, R, X, Z, L, C at single frequency
– SWR graph, 80 points
– R, X graph, 80 points
– Smith (or polar) chart, 80 points
– TDR (Time Domain Reflectometer) graph

Optional open-short-load calibration in SWR, R,X or Smith/polar chart graph modes.

RF output:
– Connector type: N
– Output signal shape: square, 0.1 to 200 MHz. For higher frequencies, harmonics of the main signal are used.
– Output power: -10 dBm (at 50 Ohm load)

Power:
– Three 1.5V, alcaline batteries, type AA *
– Three 1.2V, 1800…3000 mAh, Ni-MH batteries, type AA
– Max. 3 hours of continuous measurement, max. 2 days in stand-by mode when fully charged batteries are used
– When the analyzer is connected to a PC or a DC adapter with USB socket, it takes power from these sources

Interface:
– 320×240 color TFT displaty
– 6×3 keys on the water-proof keypad
– Multilingual menus and help screens
– USB connection to a personal computer

Dimensions:23x10x5.5 cm (9x4x2”)

Operating temperature:0…40 °C (32…104 °F)

Weight:650g (23 Oz)

* Batteries are not included with the analyzer.