Repair kit for tubeless tires amio-01251

TIRE REPAIR KIT QUICK TIRE REPAIR Perfect as a spare wheel replacement. Perfect as car equipment. Suitable for tubeless tires. The repair kit will allow you to repair punctures quickly and effectively. Its small dimensions make it very handy, so you can always have it at hand. You never know what will happen on the road, so it's worth taking a look at our set! THE SET includes a drill with a handle, an awl with a handle, 5 vulcanizing cords, 10 cm long each, 12 g glue. The set allows you to quickly repair a punctured tire. Perfect for use in the field when replacing the puncture is not possible. tires Please remember, however, that this is a temporary solution that allows us to reach our destination or the nearest tire repairer. The set is not suitable for a cut tire or a side puncture, but only in places where there is tread.  Instructions for use: 1. Remove the nail from where the tire was punctured.2. Coat the cutter with the included glue and insert it into the hole left by the nail according to the angle at which the nail entered the tire to fill the hole well with the glue.3. Thread the rope onto the awl and bend it in half, with the ends facing up.4. Coat the rope with glue and use an awl to press the strung rope into the nail hole, according to the angle of previous penetration. With a decisive movement, push the awl with the rope through the damaged place. Remember that the rope should go through the entire layer of the tire. Be careful not to pull the entire rope inside. The two ends of the rope should stick out about 0.5 - 1 cm above the tire tread. Remove the awl from the tire with a firm movement (you should not rotate the awl inside the tire while removing it - this may break it).5. Cut off the two protruding ends of the rope leaving 5mm above the tire. While driving, the string will become even with the tread surface.