Klema akumulatora mosiężna 600AMP PLUS AMIO-01660

Brass battery clamp 1 pc, car battery clamp with voltage up to 12V.

The terminals are made of brass, so they conduct electricity well and are not subject to corrosion.

These clamps are standardly installed in most vehicles. Before installing or replacing the clamps, thoroughly clean the battery connector to ensure good contact and proper charging without any losses.

Instructions for use:

• Remove the old terminals from the power cables. Clean the cables thoroughly to ensure the best possible connection.
• Loosen the clamp screws on the battery terminals. Insert the cables into the terminals, then tighten both terminal screws evenly so that the cables are held firmly and do not move. Replace the clamps on the car battery and tighten the screws firmly.

ATTENTION :

Do not hammer the terminals when attaching them to the car battery to avoid damaging the battery.