Infoadapter + steering wheel control Fiat 500x 2015 - 2021 ctuft02

The Infodapter will retain several vehicle display features after replacing the factory radio or navigation system. Vehicle-specific settings are available and will be displayed on the newly installed radio. The SWC buttons are necessary to access the Infodapter's setup menu. Not all features will be retained, such as trailer assist , E-Call, etc. Please check your factory radio and vehicle settings for available settings before installation. Check all functions before final installation. Also check our listed OEM head units and compare the wiring harness connectors shown with the connectors in your car and make sure fit optically and technically.For vehicles with steering wheel remote controlCAN busConnection: 52-pin Fiat connector Call up menu settings > connect purple/white reverse gear outputVisualize menu settings > Connect and configure yellow Cinch(m) to reversing camera inputVehicle settings and vehicle information > reflected in the rear camera input of the retrofit monitor Vehicles with voice control and phone buttons Depending on OEM vehicle equipment and software:Not all vehicle settings are supportedNot all vehicle functions are supportedNot all vehicle information is visualized Driving assistance system is not supported Vehicles with assigned OEM reversing camera OEM plug: Reversing camera adapter OEM camera 52Pin Fiat/32Pin Ford > Article: 771000-2000red: Pin 31 Video+white: Pin 32 Video -black: shielding Pin 33Brand and model:Fiat 500X (ZAF 334) 01/2015 - 08/2018 Fiat 500X (ZAF 334) 09/2018 - 2023Note: Only for vehicles with telephone button and voice function. The following signals are provided: Re-imported vehicles or vehicles with different software may have incompatible functions. Red: Ignition terminal +12V 15 Orange: Lighting terminal +12V 58 Purple/White: Feedback signal +12 V Pink: Speed ​​signal Green: Handbrake signal ground GND Remote control on steering wheel Supported vehicle settings To enter the settings, connect the feedback signal output (purple/white) to the HU To visualize the settings, connect and configure the rear view camera input HU  VP1 OEM HU setting: When the odometer is flashing, you need to enter the Infodapter menu. Press and hold the speech button for a few seconds from the main menu go to the Infodapter settings. Preferences Configuration menu try several settings from 0 to 3 (the most frequently used setting 2, try first) After changing the settings, restart the interface - disconnect the power and leave the car in standby mode for 15 - 20 minutes. This will allow the interface to send a new command to the vehicle. Note SELECT THE RADIO RECEIVER CABLE YOU WANT TO INSTALL (PURCHASE SEPARATELY)                              ALPINEBECKERBLAUPUNKTBLAUPUNKT NEW YORK /  SONYCLARIONJVCJVC KW-AVXKENWOODNAKAMICHI / PHILIPSLGPANASONICPANASONIC AVPARROT AS TEROID SMARTPIONEERPIONEER AVZENECUNIVERSAL FOR CHINESE RADIO RECEIVERS