ARCTIC P8 PWM PST case fan, 4-pin, 80mm (Black)

Case fan P8 PWM PST, 4-pin, 80mm, black.
Features:

• PWM PST technology allows you to connect multiple fans (up to 5 recommended), synchronizing their operating speed based on the actual cooling needs of the computer. This way, the entire cooling system operates more efficiently and quietly, and the overall energy consumption is lower than when connecting each fan/cooler separately.


• Maximum silence, minimum vibration. Even at low speeds, the operating sound of the new ARCTIC motor is barely noticeable. Thanks to the sinusoidal magnetization, the new motor is very smooth and almost vibration-free - it produces only about 5% of the vibration level that occurs when a conventional DC motor is turned on without a filter. As a result, the fans do not need to use anti-vibration pads.


• Optimized for static pressure. When developing the new P8 PWM PST fan, special attention was paid to focused airflow, static pressure. This fan guarantees extremely efficient cooling, even with increased air resistance.


• High-quality bearing. A combination of alloy and grease developed in Germany reduces friction in the bearing and provides greater efficiency. This results in less heat and noise from the bearing, so you can enjoy a longer lifespan for your fan.


• Longer service life. 10°C lower motor temperature approximately doubles the service life of the fan. The new ARCTIC motor has a four-times longer service life due to the low coil temperature.


• The speed is regulated via PWM PST. Thanks to the 4-pin connector, the speed can be regulated over a wide range via PWM from 200 to 3000 rpm. This way, noise is reduced to a minimum and maximum cooling is guaranteed when necessary.


• Two modes of operation. Blowing warm air out of the housing. Blowing cold air into the housing.

Technical data:

• Speed: 200-3000 rpm.


• Airflow: 23.4 CFM / 39.76 m³/h.


• Static pressure: 1.9 (mm / H2O).


• Noise level: 0.3 sone.


• Bearing: fluid dynamic bearing.


• Voltage / current 0.09A / 12V DC.


• Initial voltage: 3.4 V.


• Connector: 4-pin + 4-pin sockets.


• Cable length: 400 mm.


• Dimensions: 80x80x25 mm.


• Weight: 81 g.