Sensitive element SE-86

1. OBJECTIVE

The sensitive element is a part of the TRIBO-S fence protection system, which registers the deformation and vibration of the protected section of the fence, where the sensitive element is installed. That section of the fence is connected to the TRIBO-S processor directly or using an insensitive ( NON-SE ) cable. It is intended to protect various fences from intrusion by climbing over them or destroying them.

2. GENERAL INFORMATION

The sensitive element is a special cable that is manufactured in accordance with the technical requirements FORTEZA . The TRIBO-S processor registers the electrical charges that are the result of an intrusion attempt, generated in the sensitive element. The processor activates an alarm signal if the amount of electrical charges received in the sensitive element exceeds the threshold level.

3. INSENSITIVE ELEMENT PROVISION

STANDARD FENCES:
- carry out the work in accordance with the design documents;
- make sure that the ambient temperature is not lower than - 50C ;
- when placing the sensitive element along the fence, make sure that its radius of curvature is at least 120 mm;
- deformation nodes on various mesh fences are created using plastic straps (140 x 3.5 mm) (self-extinguishing 6.6 nylon V2 UL94 ). Temperature range - -40/+100, distance between deformation nodes - from 10 to 45 cm, which depends on the type of fence;
- deformation nodes on metal rods and wooden fences are created using 2.5 mm thick galvanized wire or other types of wire fasteners.

NON-STANDARD FENCES:
If TRIBO-S fence protection systems are used to protect non-standard fences, in this case we suggest that you first try them out when working with this type of fence. We suggest that you independently analyze the principle of operation of this device, demonstrating it to customers at exhibitions on special demonstration stands at a special demonstration price, which is significantly lower than the retail price. If you would like to receive more information, please contact us.
Prepare approximately 10 meters of the sensor element and install it on the fence (1 or 2 segments) in the way of your choice.
1) Connect it to the TRIBO-S processor and set its sensitivity.
2) Check the sensitivity of the TRIBO-S system.
3) Check the TRIBO-S system's resistance to noise (wind, vibration, shock).
4) If the TRIBO-S system detects an intruder but does not trigger an alarm due to various noises, then this placement of the sensitive element can be used on all segments of this fence. The sensitivity will be the same throughout the entire section.

4. TECHNICAL INFORMATION

The maximum length of the sensitive element ( Forteza sensitive element SE-86 ) in one zone is up to 300 m.
Operating temperature - from -40 C to +50 C.