Adapter for steering wheel control swc jeep, chrysler, dodge ram. pci bus (j1850)

Maintain the original functions of your steering wheel remote control when replacing your factory radio with an aftermarket radio. Compare the adapter plugs shown with those in your vehicle and make sure they match optically and technically. Also check if your vehicle has been fitted with one of the listed original factory radios! This interface has a loose wire that needs to be connected to the wire under your car's steering wheel cover. Full instructions are included. This interface is for vehicles that do not have CANbus wiring on the back of the radio (CANbus on the radio was introduced around 2005). The CANbus wires are white and white/orange on pins 5 and 6 in the 22-pin connector on the back of the radio. If CANbus wires are present, an alternate control interface will be required xa0CAN Index 01926 . Make and Model : Jeep Grand Cherokee (2Gen facelift (WJ)) 2002 - 2005 Jeep Cherokee (3Gen (KJ)( 2002 - 2007 Jeep Wrangler (2Gen facelift) 2003 - 2006 Chrysler Voyager (4Gen facelift) 2002 - 2008 Chrysler Grand Voyager (4Gen) 2002 - 2008 Chrysler PT Cruiser 2002 - 2005 Dodge Ram (3) 2002 - 2005Note: Analog connector: 22-pin Chrysler for vehicles without CAN-bus connection SWC under steering wheelThe following signals are transmitted: SWC