Adapter do sterowania z kierownicy Mercedes Vito (W447) 2015- CTSMC012.2

Maintain your steering wheel controls when replacing your factory head unit with an aftermarket head unit. Please compare the wiring harness connectors shown with those in your vehicle to ensure a visual and technical match. Also, verify that the OEM head units being replaced are originally installed in your vehicle.Attention:

• Note: connector CAN bus
• connector: +12V DC yellow terminal 30
• vehicles with radio preparation Before installation, check the CAN bus connection and the ISO plug assignment:
  
• incorrect connection causes damage to the interface
  
• ISO plug with assignment:
• Pin 7 : +12V Ignition Current Terminal 15
• pin 6: Lighting terminal +12V 58
  
• CAN bus connector: located in the air conditioning system
  
• Vehicles with OEM camera:
• Fakra(m) Reversing Camera Adapter> RCA(m) OEM Camera > Article: 00315
• vehicles with E-Call function:
• E-Call retention function Mercedes Sprinter/V-Class > article: 08772
• reverse gear signal not supported:
• Reverse gear signal > +12V driver side cable 1.5mm² white/blue

Make and model:

• Mercedes Vito (W447) 10/2014 - 02/2019
• Mercedes Vito (W447) 05/2019 - 2023

Steering Wheel Controls *If the interface is not working properly, if possible, code the vehicle to the OEM Audio 15 device, if possible,

Features and benefits

• Allows you to install an aftermarket OEM radio and retain the factory steering wheel controls
• Safety: Allows you to keep your hands on the wheel and focus on driving
• Plug and Play, no wire cutting required
• Retains original vehicle features such as date, time, and temperature display
• For interfaces where the phone buttons are supported, the interface allows you to answer/hang up a call in Bluetooth mode: Alpine, Clarion, Kenwood, Pioneer and ZENEC.