Brass self-locking battery clamps 2 pcs. 600A AMIO-03846

Brass battery clamps, car battery terminals up to 12V

The terminals are made of brass, so they conduct electricity well and are not subject to corrosion.

The set includes two clamps: one for the negative terminal and one for the positive terminal. These clamps are standardly installed in most vehicles. Before installing or replacing the clamps, thoroughly clean the battery connector to ensure good contact and proper charging without any losses.

Specification:

• Brass clamps (capacity up to 600A) are designed for all types of 6-12-24V batteries.
• Connection or disconnection is done without the need for tools.
• For use in passenger cars, vans, trucks and buses.
• Price per set: 2 pieces

Instructions for use:

• Remove the old terminals from the power cables. Clean the cables thoroughly to ensure the best possible connection.
• Loosen the clamp screws on the battery terminals. Insert the cables into the terminals, then tighten both terminal screws evenly so that the cables are held firmly and do not move. Replace the clamps on the car battery and tighten the screws firmly.

ATTENTION :

Do not hammer the terminals when attaching them to the car battery to avoid damaging the battery.