Adapter for Volvo XC90 2004-2014 steering wheel original amplifier + parking sensors ctsvl004.2

When replacing a factory radio with an aftermarket radio, the original steering wheel remote control functions must be retained. Depending on the vehicle equipment as well as the range of functions and software of the upgraded HU, individual operating functions may be omitted or replaced with other functions. Compare the wiring harness connectors shown with the connectors in car and make sure that they match optically and technically. Also check whether one of the listed OEM head units was originally installed. Check vehicle functionality, vehicle settings and SWC functionality before final installation. Note: CAN busvehicles with rear PDC*vehicles with OEM amplifier **vehicles with OEM silverbox tuner located in the trunk, new antenna required***vehicles without front PDCCar brand:Volvo XC90 2004 - 2014 For cars with original amplifier and factory parking sensors.*rear sensors > operation is not always assured**Amplifier OEM Front/Rear Speaker Only Bypass > Center Speaker/Subwoofer Not SupportedNote SELECT THE RADIO RECEIVER CABLE YOU WANT TO INSTALL (PURCHASE SEPARATELY)ALPINEBLAUPUNKTBLAUPUNKT NEW YORK /  SONYCLARIONJVCJVC KW-AVXKENWOODNAKAMICHI /PHILIPSLGPANASON ICPANASONIC AVPIONEERPIONEER AVZENECUUNIVERSAL FOR CHINESE RADIO RECEIVERSFeatures and advantages Allows for installation of non-factory OEM radio and retaining factory steering wheel controlsSafety: Allows you to keep your hands on the steering wheel and focus on drivingPlug and Play, no cutting of wires requiredRetains original vehicle functions such as date, time and temperature displayFor interfaces where phone buttons are supported, the interface allows Answer/Hang in Bluetooth mode: Alpine, Clarion, Kenwood, Pioneer and ZENEC.