Adapter do sterowania z kierownicy Land Rover Discovery / Range Rover Sport wzmacniacz MOST.

When replacing your factory radio with an aftermarket radio, be sure to retain the original steering wheel remote control functions. Depending on the vehicle equipment and the scope of functions and software of the retrofit device, individual operating functions may be omitted or replaced by other functions. Compare the adapter plugs shown with the plugs in your vehicle and make sure they match visually and technically. Also check if your vehicle has one of the listed original factory radios installed. Before final installation, check vehicle operation, vehicle settings, and steering wheel remote control for functionality.

Attention:

• CAN Bus
• Connection: 20-pin Land Rover connector
• Connection: OEM MOST sound system > Cinch(m) red/white
• Vehicle settings are not supported
• Date/time settings are not supported
• OEM display is not supported. Land Rover boot logo is displayed
• DIP switch settings for the manufacturer of the retrofit device (see BDA)
• Cinch(m) > front preamplifier output for retrofitted radio
• Fader function not supported

Make and model:

• Land Rover Discovery III (LA) 11/2004 - 08/2009
• Land Rover Range Rover Sport I (LS) 05/2005 - 08/2009

The following signals are provided:

• Re-imported vehicles or vehicles with different software may have incompatible features.
• red: ignition terminal +12V 15
• orange: lighting terminal +12V 58
• purple/white: +12V reverse signal
• pink: speed signal
• green: handbrake signal ground GND
• Output load capacity: max. 250 mA.
• Current requirements greater than 250 mA:
• 1 relay coil resistance 75 ohms min.
• 2 Coil resistance Ralais 150 Ohm min.
• Steering wheel remote control
• OEM sound system > muffler function not supported

General installation instructions:

Test: 1: Check all operational and vehicle setup functions of the OEM device 2: Remove the OEM unit without voltage 3: Check all interface connections for correctness and continuity without voltage

Connection and connection sequence: 1: Perform hardware setup and configuration of the interface without voltage 2: Check the radio connection cable configuration 3: Connect the radio connection cable according to the user manual of the retrofitted device 4: Make all other connections in accordance with the operating instructions of the retrofitted device. 5: Connecting the entire system to the vehicle with the live connection last 6: Configure the interface software according to the information provided in the article text and in BDA 7: Configuration of the retrofit device according to the user manual of the retrofit device steering wheel remote control/camera/FSE/antenna phantom power and others 8: Functional test of the steering wheel remote control and vehicle

Changes in the hardware configuration of the interface and the cable for connecting the radio: 1: Make changes without stress 2: Connection after modification, see 5 to 8 above

If the interface or vehicle is not functioning properly: 1: Upgrade to OEM Device 2: Support OEM device 3: Establish CAN bus silence 4: Checking the interface hardware configuration 5: Connection after CAN bus rest, see 5 to 8 above

Connections, changes to connections, alternative connections, connections of loose cables or extensions of connections of loose cables given in the information text or operating instructions are for orientation and information purposes only for trained specialist personnel.

Additional connections, changes to wiring configuration in the wiring harness, or the use of alternative connections or connection extensions: 1: Connections and changes may only be made by trained specialists 2: Before connecting, check connections and changes for any manufacturer approvals or manufacturer warranty terms that may be affected by changes 3: Before connecting, check connections and changes for functionality and correctness by measuring and comparing using the vehicle wiring diagram 4: Connections and changes are made at your own risk and functionality is not guaranteed. 5: Connections and changes are made at your own risk, without any guarantee of damage to the vehicle, retrofitted device or interface 6: Modifications to the pre-assembled wiring harness may void the product warranty.